Page 9
version 1.0.5.1 SCARAB YSiixKopta Airframe guide
www.MultiCopterPilot.com
LiPo - 4S1800-2650 - we recommend a combo of Velcro and the strap - Use a Quannum Telemetry
cell monitor to land when the first LiPo cell is 4.2->3.3v - total voltage is not as good - as one cell goes
down first!!.
NOTE : Carbon can block 2.4Ghz
RF run your Rx antenna well clear of
the carbon plates - do a range check!
Go Pro - You can run your GoPro upside down and
set the mode to upside down in the GoProUserMenu
- we recommend 720p/60fps. For YSiixKopta you
can also mount a GoPro on the rear landing gear or
use the front mount shown above - keep the mount
very firm with NO PLAY - Balancing props is essential
to removing the Gello Effect of the rolling-shutter
CMOS chip in the GoPro - new firmware for GoPro
also helps with Gello.
