Page 10
P
REPARATION FOR PROGRAMMING
• The operator has to be mounted ready for operation
• The door is not yet closed completely
• If there is a beam break (photocell), it should be connected!
☞
Advice:
If the photocell is correctly mounted and aligned, the function 'photocell' is recognized
automatically during programming!
☞
Advice:
The programming is cancelled if none of the three buttons (
%
,
&
,
$
) is actuated during
a time period of more than 120 sec.
All functions saved before with button
%
remain unchanged.
When programming is cancelled, LED
H
is flashing.
After shortly pressing button
%
the error message 1 is displayed.
!
Attention:
The operator has
two
programming levels.
For normal operation of the operator you only program the end positions and
the remote control in the Basic settings.
Changes in the extended programming level may only be carried out
by specialists.
☞
Advice:
To determine the error number add the figures of the irregularly flashing LED’s.
See as well 'error messages'.
In case of a malfunction the control light MALFUNCTION
H
is flashing.
• If applicable, before programming the operator, stick battery into your hand transmitter(s).
• When the door operator is turned on (plug in power cord) it runs a self-test;
all 4 LEDs will glow and operator 230V light will illuminate for approximately 2 seconds.
When the light is off and LED
I
is illuminated the operator is in normal operating mode.
A
DJUSTMENT
B
UTTONS
:
All settings and adjustments can be made with the three adjustment buttons.
Use
&
and
/
to change settings of chosen program menu
%
to store menu setting and go to next menu.
• Shortly press button
%
.
-> The current error number is displayed by irregularly flashing LED's
(e.g. error
N
and
X
).
