Page 5
Note:
Where the operator has been specified with a 2-piece boom, please refer to the
assembly instructions for this item supplied with the boom.
a
Install grey motorshaft adapter onto motorshaft (if not already fitted).
Bolt rail with brackets and screws to motorhousing. Make sure the screws
are tightly fastened. N.B. Use 4 large Phillips HD selftap screws provided
Lens cover should face
rear of garage.
2
Fit the red slider that re-engages the emergency release and operator pull bar onto carriage.
a. Refer to fig.1 to fit the red slider that re-engages the emergency release knob onto carriage.
b. Refer to fig.2 to fit pull bar onto carriage. Note position of emergency release cord to
ensure correct cord position after installation.
O
PERATOR
A
SSEMBLY
fig.1
fig.2
