Cardas Audio, Ltd
3
Assembly
-Strip outer jacket of the desired cable 1-1/4”
-Strip the individual conductors 3/8”
-Slide Plug end Grommet over cable
-Remove Ground retaining screw and Ground Strap from Power head
-Install stripped conductors into the end of the power pins and tighten set screw
using a 5/64” allen wrench
-Fit Bottom section of the Plug Body onto the Power Head
-Fit Wire Clamp onto the conductors and align it with the channel in the lower
Body. (Note: Grind lower half of wire clamp, if necessary, to accommodate larger
size of conductors
