10
CAUTION:
The unit should be unpacked near the desired location to avoid the risk of damage
while shifting.
1. Remove the packaging and kick plates from unit. Remove additional packaging to access the interior of the
cabinet. Be sure to keep one cardboard corner for subsequent step.
2. Using a screwdriver, remove the screws holding on the front grill. Lift grill upwards and pull away from unit
to remove. Set aside.
Note:
Re-install the front grill after placing the refrigerator in the desired location and tighten the screws with
a screwdriver.
3. Remove bolts (4) holding the unit to the pallet using the 7/16" wrench.
Note:
From this step onward, a minimum of 2 people are required. Use additional people if necessary.
Note:
It is recommended to use a forklift for double and triple door units, refer to installation with Forklift
instructions.
4. With one person on each side, gently slide the unit towards the side edge of the pallet. Slide the unit so
that there are approximately 3 inches of overhang to allow the removal of the factory installed feet and
installation of the casters.
