30
10. Troubleshooting
WARNING:
Troubleshooting procedures involve working with high voltages which can cause
injury or death. Troubleshooting should only be performed by Factory Authorized Service
Personnel.
This section is a guide for troubleshooting equipment problems. Component parts must be replaced only
with like components.
Problem
Cause
Solution
Unit does not
operate or power
failure indicator is
on
Power supply
Check that the cord is securely plugged in.
Plug another appliance into the outlet to see
if it is live.
Unit overloaded
Test the voltage and verify that it is correct
for your unit Check if there is any frost build
up on refrigeration coils. Turn unit off and
allow it to defrost. Remove contents from top
shelf of unit.
Unit runs
continuously
Dirty condenser
Clean condenser
Space temperature
too high
Control setting too high
Reset control
Inadequate air circulation
Improve air movement
Temperature
fluctuates
insufficient cooling
Temperature control
Make sure that the control is set correctly.
Condenser clogged
Make sure the condenser is clean.
Other causes
If the temperature control is set correctly,
the condenser is clean, but temperature
continues to fluctuate, call an authorized
service representative.
The equipment
makes too much
noise
The equipment is not level
Place the equipment on an even surface or
use adjustable feet.
Refrigerator
freezing
Temperature control
Reset control
Unit noisy
Loose parts or mountings
Find and tighten.
