8527-0544-2M Rev B
APS Enterprise Scale
5
INSTALLATION, CONT.
Data Cable Installation
SCALE DISPLAY/SERIAL PORT 1
Plug the RJ11 connector from the Scale Display cable into the scale base as marked.
REMOTE DISPLAY/SERIAL PORT 2
To use a remote display, plug the remote display RJ11 connector into the scale base where
marked.
POS/SERIAL PORT 3
NOTE: The included serial data cable uses an RJ11 phone type connector (scale base) to
a DB9 connector (OPOS compatible serial device).
Plug the RJ11 connector of the included 4’ serial data cable into the scale base where marked
and then plug the other end into an available serial port on the POS device.
(4’ Included Serial Data Cable, 8527-0545-0A)
(Wiring Diagram, Serial Data Cable, 8527-0545-0A)
USB Cable Installation
USB
To use the USB interface, obtain a industry standard USB cable and plug it into the scale
base where marked and then plug the other end into a USB port on your computer.
Power Adapter
12VDC
To apply power to the scale using the supplied 12VDC 1A wall plug-in UL/CSA listed AC
power adapter, insert the plug from the power adapter cable into the power jack on the scale
base where marked (refer to previous page) and then plug the power adapter into a proper
electrical outlet. The scale is now ready for operation.
4 Feet
