5
CONFIGURATION
The Scale has been pre-configured at the factory and should not require configuration for use in
most applications. In the event that the factory settings do not meet the requirements of your
application, the following describes the steps to configure the scale.
TO BEGIN CONFIGURATION:
1. Press the ON/OFF key to turn on the scale.
2. Press and hold the SET key for 3 seconds. When the display shows
Set
, release the
SET key to enter the Configuration mode. The display will change to show
Unit
.
WEIGHING UNITS
To select “lb/oz” (pounds/ounce) weighing units (10 lb x 0.1 oz):
1. With the display showing
Unit
, press the SET key. The display will change to show
“
g
” and the status (
On
or
OFF
).
2. Press the UNIT key to toggle between:
Enable (display will change to
On
) or
Disable (display will change to
OFF
).
3. Press the SET key.
4. Repeat above steps for each weighing unit mode :
• g = grams (5000g x 1 g)
• lb oz = pound ounces (10 lb x 0.1 oz)
• lb oz 1/8 = pound / 1/8 ounces (10 lb x 1/8 oz)
• lb = pounds only (10 lb x 0.005 lb)
• oz = ounces (160 oz x 0.05 oz)
• oz 1/8 = 1/8 ounces (160 oz x 1/8 oz)
5. The display will return to
UNIT
.
6. Press UNIT key to proceed to AUTOMATIC SHUTOFF
AUTOMATIC SHUTOFF
1. The display will change to AOFF .
2. Press the SET key to begin selection of the automatic shut-off time (in seconds).
3. Press the UNIT key to toggle through the selections,
120
,
180
,
240
,
300
, or
OFF
.
4. When the desired time or Off is displayed, press the SET key.
5. The display will return to
AOFF
.
6. Press UNIT key to proceed to GRAVITY COMPENSATION.
