Click here to go back to the Index.
Attaching Upper Monitors
The Upper Monitor can be installed on any piece of equipment.
For equipment with round handles or railing,
Upper Monitors are supplied with a build-in
mounting block.
Align the Upper Monitor on the handle or rail as
desired.
Use two of the supplied Plastic Wire Ties to
attach the Upper Monitor to the handle or rail.
Pull wire ties firmly to secure.
This method is the preferred method of attaching
the Upper Monitor to minimize interference with
control panels and displays.
For equipment with flat control panels but no
hand rails, SuperLock (a form of super strong
velcro) may be used.
Determine the best mounting position.
Clean the mounting surface thoroughly.
Remove the protective cover from the adhesive
strip.
Position the Upper Monitor and press firmly for
the adhesive to grip.
CAUTION: When attaching to a control panel, care
should be taken to avoid blocking access to
controls or illustrations.
Click here to go back to the Index.
Setup and Operation
