EX
90
19
Step 11:
Alignment of the feet
If the floor is uneven, you can stabilize the equipment by turning the two setting screws under the
main frame.
1. Lift the equipment on the desired side and rotate the setting screws under the main frame.
2. Rotate the screws clockwise in order to remove them and to raise the equipment.
3. Rotate them counterclockwise in order to lower the equipment.
Step 12:
Connecting the equipment to the mains supply
࣑
ATTENTION
The equipment must not be connected to a multiple socket, otherwise it cannot be guaranteed
that the equipment will be supplied with sufficient power. Technical errors can result.
Plug the power plug into a wall outlet that complies with the instructions in the chapter on electrical
safety.
**The overload switch protects from short circuits. The button jumps out in case of overload. Turn the
power switch off and then on again to restart the equipment
Summary of Contents for CST-EX90
