TX
50
31
Set the HRC type: There are two modes of HRC programmes, HRC1 – constant and HRC2- interval. Set
the preferred HRC mode with the buttons.
Set the mode: Set the speed or the incline with the buttons.
Set the age: Enter your age with the buttons.
Set the target heart rate: Enter your target heart rate with the buttons.
Set the target time: Set the programme duration of your training with the buttons.
3.4
User Setting
In the user settings you can change the screen brightness or the language
settings, for instance. Choose SAVE after your selection and press ENTER.
Symbols are displayed at the top right of the screen. When a USB stick is plugged
in, the USB symbol is displayed here; in addition, the maintenance symbol is
displayed here every 300 km to remind you to do a little service.
Information symbol:
ड
ATTENTION
The following functions are only to be used by service technicians.
Set the screen
brightness
Language selection as well as
units (metric or imperial)
Reset to default settings
Information about system software
and hardware parameters
USB drive is displayed, when you plug in
the USB stick
Maintenance symbol: is displayed every
300 km
Update function (only to be used by
the service technician)
Development environment (only to
be used by the service technician)
Summary of Contents for TX-50
