12
TX
40e
2.4
Care and maintenance
The most important maintenance measure is taking care of the running belt. This includes the adjust-
ment, tensioning and lubrication of the running belt. Damage caused due to a lack of care or negligen-
ce will not be covered by the warranty. Thus, check for maintenance in regular intervals. Be extremely
careful when adjusting and tightening the belt, because a strong over or under tension may lead to
damage. The running mat is set properly in the factory before delivery. However, the running mat may
get out of place during transport.
Adjustment of the running belt
+
During training, the running belt should run as centered and straight as possible. The alignment of
the running belt may change depending on the stress and load. Another reason can be the positio-
ning of the equipment on an uneven surface.
+
While adjusting the belt, let the equipment run with a speed of approximately 5km/h. Nobody may
be on the equipment during this process.
+
If the running belt drifts off to the left, turn the left setting screw on the rear end of the equipment
at most 1/4 rotation clockwise and the right setting screw at most 1/4 rotation counterclockwise
(fig. C).
+
If the running belt drifts off to the right, turn the right setting screw on the rear end of the equip-
ment at most 1/4 rotation clockwise and the left setting screw at most 1/4 rotation counterclockwi-
se (fig. D).
+
Then watch how the belt runs for approximately 30 seconds, because the change will not be visible
immediately.
+
Repeat the process until the running belt runs straight again. If the running mat cannot be adjusted,
please contact the contract partner.
+
If the running mat (belt) cannot be adjusted, please contact your contract partner.
Move the belt to the right
Move the belt to the left
Summary of Contents for TX40e
