7
Cardo S-800
™
1. Cardo is not liable for any incidental or consequential damages arising from the use or misuse of any of the
Company’s Products.
2. The user should never attempt to perform service, adjustments or repairs of the Product by him/herself. Doing
so will void all warranties. During the term of the warranty, all Products must be returned to the point of
purchase or the authorized service center for all necessary work.
3. The Company is not responsible for any loss or damage incurred during shipping. All repair work on the
Product by parties not explicitly authorized by the Company will void any and all warranties.
4. The information in this Manual is furnished strictly for informational purposes and is subject to change
without notice. Cardo assumes no liability or responsibility for any errors or inaccuracies that may appear in
the Manual or Quick Start Guide.
NOTE: Look for appropriate displays to verify that you are being serviced by an Authorized Cardo Dealer or Service
Center. Cardo retains the right to amend and change its Products, manuals and specifications at any time without
notice.
IMPORTANT: Cardo assumes no responsibility for direct and consequential damages, harm, merchantability or
loss of any kind, including those resulting from the use of non-Cardo components or products in conjunction with
its Products, and specifically the use of third party Bluetooth headsets or chargers. Using non-Cardo products in
connection with the BTA II is at your own risk.
WARRANTIES
FCC Notice This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this Product may not cause harmful interference, and (2) this Product must accept any interference
received, including interference that may cause undesired operation. Warning: Changes or modifications to this
unit not expressly approved by the party responsible for compliance could void the User’s authority to operate the
equipment. Use only approved batteries and chargers. This equipment has been tested and found to comply with
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. Your Product is designed to
operate at the maximum strength allowed by the FCC. This means that your Product can communicate only over
