5
English
SCALA RIDER
®
FM™ |
3. Search for
Bluetooth
devices on your phone by following the
phone’s instructions. Please consult your phone’s User Manual
for more information.
4. After a few seconds the phone will list the
scala-rider FM
as a discovered device. Select it and follow your phone’s
instructions to accept the pairing.
5. When prompted enter 0000 (four zeros) as your PIN or passkey.
6. Your phone will confirm that pairing has succeeded and the
headset will begin flashing slowly in Blue.
NOTE:
If the Pairing process is not completed within two minutes the
headset will return to Standby mode.
With some mobile phones, you may need to tap the CTRL button
to connect the headset to the phone after pairing is complete. The
SCALA RIDER FM
headset will automatically connect to the last
phone connected to the headset.
SET UP FOR BLUETOOTH GPS DEVICE
If you have a Bluetooth enabled GPS device and would
like to transmit navigation instructions and sounds from the GPS
device through the headset’s speakers, please follow instructions
described in section below “TO PAIR THE SCALA RIDER FM TO A
BLUETOOTH GPS DEVICE”
If you want to use your mobile phone and your GPS device with the
SCALA RIDER FM
headset, you should proceed as follows:
1. Pair your GPS device to your mobile phone (Please consult your GPS
device’s User Manual for more information).
2. Pair your headset to the GPS device as described below.
NOTE:
Not all
Bluetooth
enabled GPS devices allow connections to
Bluetooth
headsets like the
SCALA RIDER FM
. Please consult your GPS
device’s User Manual for more information.
TO PAIR THE SCALA RIDER FM TO A
BLUETOOTH
GPS
DEVICE:
1. Turn on your GPS device.
2. With the
SCALA RIDER FM
headset turned OFF, press and
hold the CTRL Button until the Red and Blue Lights begin
rapidly alternating.
3. Search for
Bluetooth
headsets on your GPS device by following
the device’s instructions. Please consult your GPS device’s User
Manual for more information.
4. If your GPS device prompts for a PIN or Passkey enter 0000
(four zeros).
5. Your GPS device will confirm that pairing has succeeded. The
headset will begin flashing slowly in Blue.
6. If you wish to use a
Bluetooth
mobile phone to make and
receive calls through the headset, you must now pair your
mobile phone to your GPS device by following your GPS and/
or mobile phone’s instructions.
NOTE:
If the Pairing process is not completed within two
minutes the headset will return to Standby mode.
ATTACHING THE CLAMP ON THE HELMET
The Helmet Clamp must be attached to the left side of the helmet.
Once attached, the headset unit can be mounted or released from
the Helmet Clamp at any time.. There are two methods that can be
used in order to attach the Clamp onto the helmet:
Standard Method:
Recommended for most helmet types.
Glue Plate Method:
Recommended for helmets to which the
standard method cannot be applied, using the
Glue Plate included in the box.
