English
SCALA RIDER
®
Q2
™
MultiSet |
PRIMARY BUDDY PAIRING (requires two SCALA
RIDER Q2 headsets)
1. If either headset is turned OFF, turn it ON by pressing and holding
the CTRL Button until the Blue Light flashes three times.
2. Make sure that both headsets are now flashing slowly in Blue.
3. Pick up one headset and simultaneously press and hold the CTRL
Button and MC Button for at least six seconds until the Red Light
begins flashing rapidly, indicating it is in Intercom Pairing mode.
4. Repeat Step 3 again for the second
SCALA RIDER Q2
headset.
Both headsets should now be flashing rapidly in Red.
5. Within a few seconds, both headsets will show a solid Red
light for two seconds, and then begin flashing slowly in Blue.
SECONDARY BUDDY PAIRING (requires three
SCALA RIDER Q2 headsets)
In addition to the
Primary Buddy
pairing between the two units
in your retail box you can pair your headset with the
Secondary
Buddy
headset by repeating the above pairing procedure.
NOTE:
Your headset can communicate with either the Primary
Buddy or the Secondary Buddy. However, neither
the Primary Buddy nor the Secondary Buddy can
communicate among each other directly via Intercom.
NOTE:
If the Pairing process is not completed within one
minute the headset will return to Standby mode.
STEP 2 (Optional)
SET UP FOR RIDER-TO-PASSENGER INTERCOM: PAIRING
There are two ways that the
SCALA RIDER Q2
can be used for Rider-
to-Passenger communication.
A. Both Rider and Passenger are using
SCALA RIDER Q2
headsets
(like the two units in your retail package).
To Pair the two headsets
, follow the Steps listed in the section
above titled
PRIMARY BUDDY PAIRING
.
B. The Rider is using a
SCALA RIDER Q2
and the Passenger is using
a SCALA RIDER headset (i.e. a SCALA RIDER Solo, a SCALA
RIDER FM or a SCALA RIDER TeamSet Driver unit headset)
.
To Pair the two headsets:
1. Starting with the SCALA RIDER headset turned OFF, press and hold
the CTRL button until the Red/Blue lights begin rapidly alternating.
2. Starting with the
SCALA RIDER Q2
turned ON, simultaneously
press and hold the CTRL Button and MC Button for six
seconds until the Red light begins flashing rapidly, indicating it
is in Intercom Pairing mode.
3. Within a few seconds, the
SCALA RIDER Q2
will show a solid Red
light for two seconds, and then begin flashing slowly in Blue.
NOTE:
If the Pairing process is not completed within one minute the
headset will return to Standby mode.
NOTE:
When using a SCALA RIDER headset as a Passenger headset,
Voice Connect Intercom can be initiated only by the
SCALA
RIDER Q2
headset. Manual Connect Intercom can be initi-
ated from either headset by pressing the MC button for SCALA
RIDER Q2 and CTRL button for other SCALA RIDER headsets.
RESET INTERCOM PAIRING
You can delete all of the headset’s Intercom pairings at any time.
