REMOVING:
Press here
to remove
Your headset can be removed for charging
and storage by pressing your finger
gently against the tab and sliding the
headset up with the other hand.
We recommend that you remove the
headset from the helmet when not in use.
USING THE HEADSET
GENERAL USAGE
GENERAL FUNCTIONS
DESIRED RESULT:
REQUIRED ACTION:
Turn on the
headset
Press the CTRL Button steadily for at least three
seconds
Turn off the
headset
Press the CTRL Button steadily for at least three
seconds
Increase the
volume
Short press the Volume Up Button
Decrease the
volume
Short press the Volume Down Button
AGC (Automatic Gain Control): In addition to manual Volume Control,
the
scala rider Q2
will automatically increase and reduce its volume
according to ambient noise and driving speed.
AUDIO SOURCES AND PRIORITIES
The different Audio Sources that are connected to the
scala rider Q2
are prioritized as follows:
Highest
1. Mobile phone Audio / GPS device (Incoming/outgoing calls ,
GPS audio and navigation instructions)
2. Primary Buddy Audio and Secondary Buddy Audio
3. FM Radio
Lowest
4. MP3 Connectivity
A high priority Audio Source will always interrupt any lower priority
Audio Source.
i.e.
Mobile phone call interrupts Intercom call
Intercom call interrupts FM Radio
USING THE INTERCOM
Making Intercom calls
To start a Buddy Intercom call with the Primary Buddy
while
the headset is on Standby you can either:
VOICE CONNECT:
Start talking
A Buddy Intercom call will be
established and stay on until
both sides are quiet for 30
seconds.
MC BUTTON CONNECT:
Single tap the MC Button
A Buddy Intercom call will
be established. To end the
Buddy Intercom call, single
tap the MC Button again.
To start a Buddy Intercom call with the Secondary Buddy
while the headset is on Standby:
MC BUTTON CONNECT:
Double tap the MC Button
A Buddy Intercom call will be established. To end the
Buddy Intercom call, double tap the MC Button again.
NOTE:
When using a scala rider Headset (not a Q2 version) as a
Passenger headset, Voice Connect Intercom can be initiated only
by the
scala rider Q2
headset. Manual Connect Intercom can be
initiated from either headset.
Failed Connection:
On the
scala rider Q2
, if you attempt to start
a Buddy Intercom call with a Buddy that is already on a Phone/GPS/
Intercom call, you will hear a double beep indicating the Buddy is busy.
or
MC Button
9
scala rider
®
Q2
™
English
