7
| INTERCOM
Note: MultiSet units are already factory paired!
Pairing
Your Q3 unit has 3 Intercom channels allowing separate connections
with 3 other riders .
In Standby, press “IC” for 5 seconds on both units until LEDs begin
flashing rapidly. Then:
to pair Channel A
No action required - Rapid RED LED flashing
to pair Channel B
Double tap “IC” - Rapid BLUE LED flashing
to pair Channel C
Triple tap “IC” - Rapid PURPLE LED flashing
Calling
Call Channel A
Tap “IC”
Call Channel B
Double tap “IC”
Call Channel C
Triple tap “IC”
Voice Connect (VOX)
Call Priority
Intercom
Channel
Speak any word loudly into the microphone to activate
the VOX. An intercom call will start automatically
Set Priority
Intercom
Channel
Press “V+” for 5 seconds during intercom call with the
selected channel
8
| CLICK TO LINK® (“CTL”) CALLS
Send a “CTL” call request
(search lasts up to
10 seconds)
In standby, press “MM” for 2 seconds
End a “CTL” call /
Cancel “CTL” request
Tap “IC”
Accept a “CTL” call
When hearing the
CTL
ringtone:
Tap “IC” or say any word loudly to answer
by VOX
Reject a “CTL” call
Remain silent until the
CTL
ringtone stops or
press “IC” for 2 seconds
Enable/Disable “CTL”
(Enabled by default)
Via the Voice Menu or the
Cardo Community
9
| RADIO STATION TUNING
Seek up/down and Save
Choose a preset by tapping “MM”
Press “V+” or “V-” for 2 seconds
Tap “MM” within 20 seconds to save to
current preset
Scan: Automatically
scans up for a station
With Radio ON, press “V+” for 5 seconds
To stop search, tap “V+” or “V-”
Tap “MM” within 20 seconds to save to
current preset
Automatic Radio Tuning:
Save 6 Temporary
Stations
With Radio ON, press “V-” for 5 seconds
Enable / Disable RDS
With Radio ON, press “V+” and “V-”
simultaneously for 2 seconds
M
AN
01
00
3 Q
3 Q
G E
N R
_
J 0
05
10
| CARDO COMMUNITY® PLATFORM
Visit
http://community.cardosystems.com
to:
• Register your device for warranty and technical support
• Download and install the latest software upgrades
• Customize settings
11
Reboot
If your scala rider stops responding reset it by
turning it off and then on again (press “IC” for
2 seconds).
Reset Pairing
(Deletes all
paired devices)
1. In Standby, press “V+” for 5 seconds until LED
flashes RED/BLUE.
2. Press “MM” for 2 seconds until LED flashes
5 times in PURPLE and unit turns off.
The contents of this Quick Guide, including all text, illustrations and drawings are
the exclusive intellectual property of Cardo Systems, Inc. (the “Company”) and are
protected by copyright laws. Any partial or total reproduction, translation and or
dissemination, without the prior written authorization by the Company are strictly
prohibited. Any rights not expressly granted herein are reserved.
Intercom
Button
(“IC”)
Music / Mobile
Button
(“MM”)
Volume Up
(
“V+”
)
Volume Down
(
“V-”
)
www.cardosystems.com
support@cardosystems.com
USA & Canada: 1-800-488-0363; International: +49 89 450 36819
