USING THE MP3 PLAYER WITH YOUR
HEADSET
Your
scala rider
TeamSet
pro
headset can be connected to
an MP3 player device by plugging it to the Helmet Clamp’s
jack with the MP3 cable.
At your option, you may further secure the MP3 cable by
using the MP3 cable holder. For this purpose please proceed as
follows:
MP3 cable holder hook
1. Use the enclosed Allen Wrench to
remove both Allen screws from
Helmet clamp and release the
clamp’s back plate.
2. Place the MP3 cable holder on the
helmet clamp. Both pins on the
MP3 cable holder should be fixed
into corresponding indentations on clamp.
3. Place the Back Plate on top of the MP3 cable holder and secure
all parts together using the Allen screws that were previously
removed, as shown in photo.
4. Attach the clamp and headset onto your helmet as described
previously in section “ATTACHING THE CLAMP ON THE HELMET”.
5. Attach the speakers to your helmet as described in section
”POSITIONING THE SPEAKERS”.
Insert cable in hook
6. Connect the MP3 cable to your MP3
player device’s jack and the other
side to the helmet Clamp’s jack,
inserting the cable through the MP3
cable holder.
Make sure that the cable plug clicks
into place.
7. Tuck the MP3 cable into the hook of the MP3 cable holder.
8. In order to use your MP3 player, power on the headset to have it
on Standby mode, flashing slowly in Blue.
NOTE:
Operate the MP3 Player device by using its buttons (FF/REW/
PLAY/PAUSE).
Volume can only be adjusted through the MP3 Player.
Any other audio connection will automatically mute the MP3
Player. The audio signal will return only when headset is once
again in Standby mode.
SUPPORT
For additional information please visit our website at
www.cardosystems.com
FAQ:
www.cardosystems.com/support/faq
or contact us at:
support@cardosystems.com
Phone:
USA and Canada:
+ 1-800-488-0363
International:
+4989 450 36819
NOTICES
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class
10
scala rider
®
TeamSet
™
PRO
