TROUBLESHOOTING THE INTERCOM:
First, make sure your microphone is located properly in front of
the center of your mouth.
The scala rider
TeamSet
pro
is designed for use in loud
environments. Please make sure to test the Intercom
functionality in a LOUD environment, such as next to an idling
motorcycle.
Please also verify that the headsets were paired together properly
by following the instructions in the relevant Setup sections.
Enable/Disable Voice Connect feature (VOX)
The
scala rider
TeamSet
pro
offers VOX technology for safe and
hands-free operation of some key functions.
For incoming calls, just pronounce loudly any word (e.g. “hello”). To
reject an incoming call, you need only to remain silent for about 15
seconds. To reject an intercom call remain silent for 30 seconds.
While on standby press and hold the Volume Up and Volume Down
Buttons simultaneously for three seconds until you hear a beep. The
default status is Voice Connect enabled.
NOTE:
The Enable/Disable Voice Connect feature affects only the
Intercom functionality.
MAKING AND RECEIVING MOBILE
PHONE CALLS
PHONE FUNCTIONS
Answer a call
Tap the CTRL Button or speak loudly any word
of your choice during an incoming call.
Reject a call
Tap the Intercom Button or remain silent for
15 seconds during an incoming call.
PHONE FUNCTIONS
Terminate a call
Tap the CTRL Button to end a call.
Voice Dial
During Standby, tap the CTRL Button and
state the name of the person you wish to
call. This feature is supported only by mobile
phones that support the Voice Dial feature.
Redial
Press and hold the Volume Down Button for
three seconds during Standby.
NOTE:
If your
Bluetooth
mobile phone is paired to a
Bluetooth
GPS
device, not directly to the
scala rider
TeamSet
pro
, some of the
above Phone functions may not be available.
When the headset is on an active phone call, any Buddy Intercom call
request will be rejected automatically.
Once the phone call audio link drops, you can initiate and accept
Buddy Intercom calls.
STATUS LIGHT STATES
None
Headset is off
Alternating red/blue flashes
Mobile phone/GPS Pairing mode
Rapid red flashes
Intercom Pairing mode
1 blue flash every 3 seconds
Standby – No call is in progress
2 blue flashes every 3 seconds
Call is in progress
1 red flash every 3 seconds
Battery is low
2 red flashes every 3 seconds
Low battery while a call is in
progress
Solid red
Headset is being charged
En
glis
h
9
scala rider
®
TeamSet
™
PRO
