Cardo Systems SCALA RIDER TEAMSET, User Manual

6

| SCALA RIDER

® 

TeamSet™

ATTACHING THE CLAMP ON THE HELMET

Perform this procedure for both the driver and the passenger helmets. 

The Helmet Clamp must be attached to the left side of the helmet. Once 

attached, the headset unit can be mounted or released from the Helmet 

Clamp at any time. 

There are two methods that can be used in order to attach the Clamp 

onto the helmet:

Standard Method:

Recommended for most helmet types.

Glue Plate Method: 

Recommended for helmets to which the 

standard method cannot be applied, using the Glue Plate included 

in the box.  

Standard Method

1. Use the enclosed Allen Wrench to loosen the 

two screws on the Back Plate.

2. Slide the Back Plate between the internal padding 

and the external shell of the helmet. 

3. Adjust the clamp’s location so that the 

microphone is located opposite center of 

your mouth and then tighten the screws. 

You may need to reposition the Clamp 

repeatedly until you identify the best 

spot. The microphone must be positioned 

vertically and not horizontally.

Glue Plate Method

You have the option to glue the Helmet Clamp onto your helmet, when 

the above standard method cannot be used, or in case you prefer to 

secure the Helmet Clamp with adhesive glue. This option has been 

successfully used for a range of high end helmets.

NOTE: 

While we have no reason to believe that the gluing 

option might negatively affect any helmet, Cardo 

does not assume any responsibility to that affect, ir-

respective of its nature and circumstances. The Glue 

Plate is offered as a free option that you may choose 

to use at your own risk and subject to renouncement 

of any future claims.

Caution: 

This process can be done only once! 

1. Use the enclosed Allen Wrench to remove both Allen screws 

and release the Helmet Clamp’s back plate.

2. Determine the location on the helmet where the 

Helmet Clamp must be attached.

3. Adjust the Helmet Clamp’s location on the Helmet so that 

the microphone is located opposite the center of your mouth. You 

may need to reposition the Clamp repeatedly until you identify the 

best spot. The microphone must be positioned 

vertically and not horizontally (Be sure to clean 

the selected area prior to the gluing process as 

described in # 4 below).

4. Use the pre-moistened Towelette to clean the helmet area where 

you want to install the Glue Plate. Allow to dry thoroughly.

5. Peel the foil cover from the Glue Plates’ adhesive pad. 
6. Place the Glue Plate into position according to #3. Press firmly 15 

seconds on all 3 parts of the Glue Plate.

7. The adhesive pad bonds to full strength over the next 24 hours. 

Therefore it is recommended to not use the headset during this 24 

hour period. 

8. Fasten the Clamp to the Glue Plate using the Allen screws that were 

previously removed.