Cardo Systems SCALA RIDER TEAMSET, User Manual

8

| SCALA RIDER

® 

TeamSet™

Connect the audio cable to 

the helmet Clamp’s jack

1. Power on the headset to have it on 

Standby mode, flashing slowly in Blue.

2. Connect one side of the audio cable 

to your MP3 player/audio device’s 

jack and the other side to the helmet 

Clamp’s jack as shown in the photo.

3. Operate the MP3 Player/audio device 

by using its buttons (FF / REW / PLAY 

/ PAUSE ).

NOTE:

Volume can only be adjusted through the MP3 Player. Any other 

audio connection will automatically mute the MP3 Player. The 

audio signal will return only when headset is once again in 

Standby mode.

DRIVER’S UNIT FUNCTIONS

USING THE HEADSET

G E N E R A L     F U N C T I O N S

DESIRED RESULT:

REQUIRED ACTION:

Turn on the 

headset

Press the CTRL Button steadily for at least 6 seconds. 

Led indication: three blue flashes. 

Audio feedback: Ascending tone (low-high).

Turn off the 

headset

Press the CTRL Button steadily for at least 3 seconds. 

Led indication: three red flashes. 

Audio feedback: Descending tone (high-low).

Increase volume

Tap the Volume Up Button

Decrease volume

Tap the Volume Down Button

AGC (Automatic Gain Control): In addition to manual Volume Control, 

the 

SCALA RIDER TeamSet 

will automatically increase and reduce its 

volume according to ambient noise and driving speed.

INITIATING AND RECEIVING MOBILE 

PHONE CALLS

Voice Recognition (VR)

The VR feature allows you to answer or reject incoming calls by voice 

Control without having to remove your hands from the handlebars. 

The default mode of this feature is ON (enabled).

Each time you switch off and turn on the headset, the VR feature will 

be automatically enabled.

To disable / enable the VR feature see phone functions below.

Note:

The VR feature works well while driving up to 70km/h 

or 44m/h with 3/4 helmet and up to 120km/h or 75m/h 

with a closed full-faced helmet

.

PHONE FUNCTIONS

Answer a call

Tap the CTRL Button or speak loudly any word of 

your choice.

Reject a call

Tap the Intercom Button or remain silent for 15 

seconds during an incoming call.

Terminate a call

Press and hold the Intercom Button for 3  

seconds when a call is in progress. For some 

mobile phones you may need to press the  

Control button to end the call.

Voice Dial

During Standby, tap the CTRL Button and state the 

name of the person you wish to call. This feature 

is supported only by mobile phones that support 

the Voice Dial feature.

Redial

During Standby, tap the Intercom Button

Enable/Disable 

voice command 

feature

 Long press the volume up and down buttons simul-

taneously until you hear a beep. The default status is 

voice command enabled.