3
English
SCALA RIDER
®
|
Left Speaker
(short cord)
Wall Charger
Allen Wrench
Velcro Pads
Glue Plate
Pre-moistened Towelette
Carry-Pouch
Microphone Sponges
Flat sponge for full-face helmets and round sponge for other helmet types
User Guide, including Warranty and Registration form
IMPORTANT:
The
SCALA RIDER
is a water-resistant device, designed for use under
moderate rain or snow conditions. However, the
headset is not
waterproof
and should not be used under severe weather conditions.
The cover tongue protecting the Charging Jack should be kept tightly
closed at all times to prevent moisture from entering the device.
BEFORE USING (CHARGING THE
HEADSET)
Make sure that the headset is fully charged for at least four hours
before initial use.
1. Connect the wall charger to the headset’s Charging Jack (located
between the two Volume Buttons).
2. While charging, the Red Light turns on (it may take up to 15
seconds until the Red Light turns on). When charging is complete,
the Red Light will turn off.
SET UP AND CONFIGURATION
SET UP FOR MOBILE PHONE CALLS
If you have a
Bluetooth
enabled mobile phone and would like
to make and receive phone calls using the
SCALA RIDER
, you
must first pair your headset to the mobile phone.
Pairing is a one time process. Once the headset is paired to a
specific mobile phone during this Setup Procedure, they will
remain paired and automatically recognize each other whenever
they are within range. If the connection between the phone and
headset is lost, tap the CTRL button to reconnect the devices.
TO PAIR THE SCALA RIDER TO A BLUETOOTH MOBILE PHONE
1. Turn on your phone and make sure its
Bluetooth
function is
activated.
2. With the
SCALA RIDER
headset turned OFF, press and hold
the CTRL Button until the Red and Blue Lights begin rapidly
alternating.
Mobile Phone
GPS
QG SOLO 014 - QG0143.indd 3
9/4/08 1:02:44 PM
