MAKING AND RECEIVING MOBILE
PHONE CALLS
PHONE FUNCTIONS
Answer a call
Tap the CTRL Button or speak loudly any word
of your choice during an incoming call.
Reject a call
Tap the MC Button or remain silent for 15
seconds during an incoming call.
Terminate a call
Tap the CTRL Button to end a call.
Voice Dial
During Standby, Tap the CTRL Button and
state the name of the person you wish to
call. This feature is supported only by mobile
phones that support the Voice Dial feature.
Redial
During Standby, press and hold the Volume
Down Button for three seconds.
NOTES:
If your
Bluetooth
mobile phone is paired to a
Bluetooth
GPS
device, not directly to the
scala rider Q2
pro
, some of the above
Phone functions may not be compatible.
When the headset is on an active phone call, any Buddy Intercom call
request will be rejected automatically.
Once the phone call audio link drops, you can initiate and accept
Buddy Intercom calls.
STATUS LIGHT STATES
None
Headset is off
Alternating red and Blue
flashes
Mobile phone Pairing mode
Simultaneous red and Blue
flashes
GPS Pairing mode
Rapid Red flashes
Intercom Pairing mode
1 blue flash every 3 seconds
Standby – No call is in progress
2 blue flashes every 3 seconds
Audio is on
1 red flash every 3 seconds
Standby – Battery is low
2 red flashes every 3 seconds
Low battery while audio is on
Solid red
Headset is being charged
WORKING WITH THE FM RADIO
Your headset is equipped with an FM Radio receiver and RDS (Radio
Data System) technology, allowing you to choose how and when you
listen to your favorite stations.
The
scala rider Q2
pro
enables you to listen to FM Radio while you
are not receiving audio from another audio source.
While listening to the radio, you do not have to worry about missing
any calls, as the headset automatically mutes the FM Radio and
switches to
Bluetooth
headset operation when an incoming call is
received, or when you decide to initiate a call. When the conversation
is over, the headset automatically tunes back in to the FM Radio.
The RDS Feature
Thanks to the RDS feature, your headset will automatically select the
strongest signal available for the FM station you wish to listen to, no
matter where you are riding. This allows you to leave your hands on
the handlebars at all times with no need to adjust the radio station
frequency while you are in motion.
To use the RDS feature while the Radio is on, press and hold the
Volume Up and Volume Down Buttons simultaneously for 3 seconds.
The headset will display a solid blue light indicating that the RDS
function is enabled. The headset will display a solid red light
indicating that the RDS function is disabled.
En
glis
h
11
scala rider
®
Q2
™
MultiSet
pro
