PRIMARY BUDDY PAIRING (
two scala rider Q2
pro
headsets*)
Your MultiSet
pro
units are already factory paired and ready for use. If
for any reason, you have to pair them again, proceed as follows:
1. If either headset is turned OFF, turn it ON by pressing and holding
the CTRL Button until the Blue Light flashes three times.
2. Make sure that both headsets are now flashing slowly in Blue.
3. Pick up one headset and simultaneously press and hold the CTRL
Button and MC Button for at least six seconds until the Red Light
begins flashing rapidly, indicating it is in Intercom Pairing mode.
4. Repeat Step 3 again for the second
scala rider Q2
pro
headset.
Both headsets should now be flashing rapidly in Red.
5. Within a few seconds, both headsets will show a solid Red
light for two seconds, and then begin flashing slowly in Blue.
NOTE:
If the Pairing process is not completed within two
minutes the headset will return to Standby mode.
* Same process is applicable also for pairing with the Q2, i.e. the predecessor
of the Q2 PRO.
SECONDARY BUDDY PAIRING (requires
three
scala rider Q2
pro
headsets*)
In addition to the
Primary Buddy
pairing between the two units
in your retail box you can pair your headset with the
Secondary
Buddy
headset by repeating the above pairing procedure.
NOTE:
Your headset can communicate with either the Primary
Buddy or the Secondary Buddy. However, neither
the Primary Buddy nor the Secondary Buddy can
communicate among each other directly via Intercom.
NOTE:
If the Pairing process is not completed within two
minutes the headset will return to Standby mode.
* Same process is applicable also for pairing with the Q2, i.e. the predecessor
of the Q2 PRO.
SET UP FOR RIDER-TO-PASSENGER
INTERCOM: PAIRING
There are two ways that the
scala rider Q2
pro
can be used for
Driver-to-Passenger communication.
A. Both Rider and Passenger are using
scala rider Q2
pro
headsets
(like the two units in your retail package).
To Pair the two headsets
, follow the Steps listed in the section
above titled
PRIMARY BUDDY PAIRING (2 bikers)
B. The Rider is using a
scala rider Q2
pro
and the Passenger is
using an earlier scala rider headset (i.e. a scala rider Solo, a
scala rider FM, a scala rider TeamSet Driver unit or TeamSet
pro
headset)
.
To Pair the two headsets:
1. Starting with the earlier scala rider headset turned OFF, press
and hold the CTRL button until the Red/Blue lights begin
rapidly alternating.
2. Starting with the
scala rider Q2
pro
turned ON,
simultaneously press and hold the CTRL Button and MC
Button for six seconds until the Red light begins flashing
rapidly, indicating it is in Intercom Pairing mode.
3. Within a few seconds, the
scala rider Q2
pro
will show a solid Red
light for two seconds, and then begin flashing slowly in Blue.
NOTES:
If the Pairing process is not completed within two minutes
the headset will return to Standby mode.
When using an earlier scala rider headset as a Passenger
headset, Voice Connect Intercom can be initiated only by the
scala rider Q2
pro
headset.
En
glis
h
5
scala rider
®
Q2
™
MultiSet
pro
