DRAFT
Page 9 of 19
If the other party terminates the call first, you don't have to do anything.
Wait at least three seconds before pressing the CTRL button to start voice dialing.
NOTE:
If your mobile phone does not support the
handsfree
protocol you will not
be able to end calls by pressing the Reject/redial/End Button. Instead, please tap
the CTRL button to terminate calls.
5.5
Volume Control
The scala-rider headset comes equipped with AGC technology to automatically
adjust itself to the optimal speaker volume. Its embedded sensors continuously
measure the ambient noise and driving speed to make manual adjustment of the
volume buttons virtually unnecessary.
Irrespective of this feature, you can adjust the volume anytime by pressing the
volume buttons one step at a time (FIG. 8). For each step of adjustment, you will
hear a short beep.
5.6
Call Reject
While you hear the ring tone on the headset, there are two ways you can reject the
call:
- Tap the Redial/Reject/End button on your headset to reject the call (FIG. 9).
- Assuming the VR feature is enabled (see section 7 below), remain silent for 7
seconds to reject the incoming call.
Tap here to reject the
call or initiate redial
FIG. 9
Press here to decrease the
volume
Press here to increase
the volume
FIG.8
Tap here to terminate
the call
FIG. 7
