Cardo Systems SHO-01, User Manual

☛

 OPTION 2: Manual Mode

SAY THE NAME

CHOOSE THE NAME  

(from your Buddy List):

Tap 

 and say the name of 

the “1+8” Buddy

Press 

 for 2 seconds. Hear 

the names of all pre-paired 

“1+8” buddies. 

When you hear the name 

of the Buddy you wish to 

call, tap 

 or say any word 

loudly into the microphone. 

To cancel Buddy List playback: 

Press 

 for 2 seconds.

5.1e INTERCOM-TO-PHONE

If a “1+8” Buddy is not in range, or moves out of range, you have 

the option to set up the “Intercom-to-Phone” feature via the 

Cardo Community, to remain in contact by diverting Intercom calls 

automatically to your mobile phones.

5.2 INTERCOM WITH CHANNELS “A” AND “B”

Start multi-party conversations using Intercom Channels “A” and 

“B”. This mode is suitable for 2, 3 or 4-way calls.

5.2a PAIRING INTERCOM CHANNELS “A” AND “B”
Pairing a Channel will replace any existing paired device on that 

Channel with the newly paired device.

If you have purchased the cardo SHO-1 DUO, both units are 

factory-paired and configured to communicate via Channel 

“A”

. If 

for any reason you have to pair them again, OR if you wish to pair a 

different unit to make Intercom calls, proceed as follows:

1. Check that all units are in Standby.

2.   Press 

 for 5 seconds until the LED begins flashing rapidly, 

indicating it is in Intercom Pairing mode (see table below for 

channel pairing).

3.  Enter Intercom Pairing mode on the second unit following its 

user manual. Both units will now be in Intercom Pairing mode.

4.  After a few seconds, both units will show a solid LED for 2 seconds, 

indicating that they are paired and ready to use.

5.  If Pairing is not completed within two minutes, the units will 

return to Standby mode.

CHANNEL PAIRING METHOD

LED INDICATORS

“A”

In Standby, press 

 for 5 seconds. 

Channel “A” pairs automatically.

Rapid RED 

flashing

“B”

In Standby, press 

 for 5 seconds.  

When LED begins flashing , tap 

 twice.

Rapid BLUE 

flashing

5.2b CALLING INTERCOM CHANNELS “A” AND “B”

There are two ways to start an intercom call with Channels “A” and “B”

OPTION 1: Voice Connect (VOX) 

Speak any word loudly into the microphone. When you hear the 

Voice Command tone, say “Call Intercom” to start an intercom call 

with “A” and/or “B” (subject to who is present)
VOX Intercom call with only “A” or “B” will end automatically after 

30 seconds of silence.

☛

 OPTION 2: Manual Mode

Use this to start an Intercom call with either:

• Channel “A”: Tap 
• Channel “B”: Double-tap 

English

cardo SHO-1 

| 

9