4.4 BASIC FUNCTIONS
To turn the volume up for current audio source:
●
Tap
.
With each tap, a louder tone is played on the speaker until you reach the maximum volume, as indicated by the
maximum volume tone.
To turn the volume down for current audio source:
●
Tap
.
With each tap, a quieter tone is played on the speaker until you reach the minimum volume, as indicated by the
minimum volume tone.
To mute the microphone completely and lower the speaker volume to the minimal level when an audio source is active:
●
Tap
and
.
A descending tone is played on the speaker.
To unmute the microphone and raise the speaker volume to the previous level when an audio source is active:
●
Tap
and
.
A ascending tone is played on the speaker.
Automatic Gain Control (AGC) adjusts your speaker volume according to ambient noise and riding speed. To
adjust AGC sensitivity, see
Configuring Your SMARTH Basic Settings through the SmartSet App
on page 36.
4.5 PAIRING YOUR UNIT TO BLUETOOTH DEVICES
Your SMART
H
has two Bluetooth channels for connection to Bluetooth devices such as mobile phones, GPS devices
and Bluetooth music players with A2DP.
To connect your SMART
H
to a Bluetooth device, you must first pair them while in Standby (see
SMARTH Modes and
Events - LED Indications
on page 49). Once paired, they automatically recognize each other whenever they are within
range.
4.5.1 PAIRING THROUGH THE UNIT BUTTONS
If you are pairing more than one device, Cardo recommends that you pair the mobile phone to channel 1, and the
additional device (such as GPS, music player or additional mobile phone) to channel 2.
To pair Bluetooth channel 1 to a mobile phone:
1.
Enable Bluetooth on the mobile phone.
2.
Press
for 5 seconds. The LED flashes red and blue.
3.
Search for Bluetooth devices on your mobile phone as described in your phone's instructions.
4.
After a few seconds the phone lists your SMART
H
. Select it.
5.
If prompted for a PIN or Passkey, enter 0000 (four zeros).
6.
The phone confirms that pairing has succeeded and the LED flashes purple for 2 seconds.
To pair Bluetooth channel 2 to another Bluetooth device:
1.
Enable Bluetooth on the device (such as mobile phone, GPS device, music player).
2.
Press
for 5 seconds. The LED flashes red and blue.
9
