where there will be many chest belts without cross talk
and interference. Hold ‘MODE’ key for 3 seconds, LCD
will display ‘PULSE PAIR ‘ (
- - -) ‘ then bring the front
center of the chest belt towards the embedded magnet
on the top of the console for few gentle back and forth
swipes as shown in the following images.
If the Heart Rate value is displayed on LCD, it means
that the pair stage is successfully completed.
On the other hand, if the monitor displays ‘Err’, it means
that the pair stage is failed. Then the user can press
‘SET’ key, and repeat the pair stage again. Alternatively,
it will exit the pair stage automatically after 10 seconds
with the memory of previous paired chest belt.
SPEED PAIR STAGE
(Exclusive in DT-3260C & DT-3261C)
Note: All models will be paired right after produced
For commercial and maintenance purpose – press and
Hold both ‘MODE’ and ‘’SET’ key for 3 seconds to go into
the SPEED PAIR STAGE. The user will have to press
the small ‘SPEED CONTROL PAIR KEY’ on the speed
transmitter to actively sending signals to the console for
pair stage.
If the number ‘0’ is displayed on LCD, it means that the
pair stage is successfully completed. On the other hand,
if the monitor displays ‘Err’, it means that the pair stage
is failed. Then the user can press ‘SET’ key, and repeat
