CareCo Access-Tec MS09130 Setup Manual Download

Page: 4 / 6

www.careco.co.uk

CareCo, Hubert Road, Brentwood, Essex, CM14 4JE

Setup Guide

• You can then turn the ramp back over.

• Secure each bracket into place with 2x 25mm Hex Bolts, 2x Washers and 2x Lock

Washers (place the Lock Washer and then the Washer onto each Hex Bolt
before screwing in).

• The bolts can be tightened with the Allen key supplied in the kit.
• Repeat this process for all four brackets at every corner of the ramp.

• Next, you want to attach the 4x vertical posts.
• Attach the vertical post onto the ramp, by sliding the holes at the bottom of the post

through the studs on the outside of the ramp.

• Secure this with 2x Washers and 2x Lock nuts, using a 13mm socket.
• Repeat this process for all four vertical posts at each corner.

Summary of Contents for Access-Tec MS09130

Page 1: ... 6ft and 7ft and they can all be assembled in the same way demonstrated below User Manual Instruction and Assembly Manual www careco co uk CareCo Hubert Road Brentwood Essex CM14 4JE Product Code MS09130 Access Tec Ramp with Handrail Packaging 5 ft Access Tec Ramp with Handrail MS09130 5 5 ft Product Code Product Code MS09130 Setup Guide ...

Page 2: ...x CM14 4JE Setup Guide Parts Included 1 2 2 3 3 4x Handrails 2 1x Ramp 1 8x Set Screws 6 8x Lock Nuts 5 2x Clevis Pins 11 4x Brackets 4 4x Vertical Posts 3 2x Allen Keys 8 8x 25mm Hex Bolt 7 16x Washers 9 8x Lock Washers 10 4 9 10 11 5 6 8 Fixing Kit 7 ...

Page 3: ...e down Locate the 4 holes found on either side of the ramp as highlighted by the red circles Slide one of the brackets onto the ramp from the corner lining up the two holes found on the bracket with the two holes found in that corner of the ramp The upper lip of the end of the bracket will extend into the groove under the ramp side rail ...

Page 5: ...o that the handrails can fit through the holes in the vertical posts IMG 1 The handrails should then be able to slide through and can be secured by placing the cap back onto the end IMG 2 Repeat this so that there is an upper and lower hand rail on both sides of the ramp Finally to secure the handrails in place fasten with the set screws as displayed above IMG 1 IMG 2 ...