PAGE 4
Folding & Transporting
Note: The folding procedure is essentially the assembly procedure in reverse.
3. Flip up the footplates and lift up the footplate receivers. Press the brass push
button and push the footplate back whilst rotating approximately 90º until it
locates in the receiver hole nearest the chair.
4. Lift the chair by the two lift up straps and the chair should naturally fold up. The
chair can be carried using the lift up straps.
5. If required, unzip the carry bag and insert the chair. If necessary, rotate the front
castors to allow the chair to fit in the bag. Zip up the bag and carry using the two
handles.
1. Press the release paddle on the half fold
back mechanism with your thumb whilst
lightly pulling the push handle down.
2. Pull the armrest release button whilst pulling
up on the armrest to release. Flip the armrest
back until they are hanging vertically down
from the chair.
Brake Operation
The Avigo Compact Wheelchair comes with
two brakes which should only be applied
when the chair is stationary.
To apply the brakes, press the brake handle
as shown in the photo. To release the brakes,
press the handle in the opposite direction.
The Avigo Compact Wheelchair is not suitable for use a seat in a motor vehicle.
Users should always transfer to the vehicle’s seat.
