C
C
C
C
C
C
B
C
D
A
E
E
C
Step 4
Check to ensure that the tent cover is
spread in the right direction.
Let the 2 unconnected tubes pass through
the ground sleeves of the cover.
Step 5
Let the last C tube pass through the ground sleeve
of the cover and connect it with assembly A and B.
Step 6
Fold the cover backwards over the frame, wrap the
velcros around the rib as appropriate, and tidy up the
whole tent.
Secure the frame
Weights can be placed on the flat bar connected to the D plate. Bolts can be used to fasten the swivel plates of
A & B to concrete or other firm surfaces.
Fold down and storage
The CareCo Mobility Store is designed to fold down for storage as needed. While the Mobility Store is still fully
assembled, remove the bolts for the A frame and take out the H tubes. The Motor tent can then collapse closed
pivoting on the A and B base assemblies. Tie the ribs together at the top and then you can easily move it around.
One Year Limited Warranty
For one (1) year from the date of delivery, we will replace at our discretion to the original purchaser any part
found faulty upon examination by an authorized representative of CareCo. CareCo are not liable for damage
caused by an act of god, for example a heavy thunderstorm or gale force winds.
CareCo UK Limited , Hubert Road, Brentwood, Essex, CM14 4JE | 0333 015 5000
Step 3
Connect D. Then lift the assemblies with all ribs and connect C
across the A & B frames.
Leave the last C tube uninstalled for this step as the picture shows.
J
K
K
J
Padlock
Locked /
Open
M
M
Use parts J,K and
M for the locking
device. See picture
below.
