C
AREFREE OF
C
OLORADO
S
UNDIAL
P
ATIO
A
WNING W
/
M
ANUAL
O
VERRIDE
10
052537-001r5
1. Connect control box to power source (110VAC).
2. Press the Programming Button (PROG) of the receiver located in control box (lower right corner) until LED
illuminates. This indicates that for one (1) minute the receiver is ready to receive the address of the transmitter.
After this time, the control box exits the programming mode and the LED goes out.
3. For multiple channel transmitters, use the channel selector until the 1
st
channel (LED) is illuminated.
4. Press the Programming Button on the transmitter with a ballpoint pen until the receiver’s LED blinks
rapidly and shuts off. The address of the transmitter is instantly memorized and the receiver
automatically ends the programming mode.
5. For multiple channel transmitters:
•
To set the group control, Use the channel selector until all 4 LEDs are blinking, this is the group
(master) channel. Repeat steps 5 & 7.
•
Repeat the above steps for each control box using the channel selector to set the channel to #2 for
the second control box, #3 for the third control box and #4 for the fourth box. For each control box
also set the master channel.
6. Test operation. The "UP" arrow should retract the awning; the "DOWN" arrow should extend the awning. If
the awning works opposite the switch markings, reverse the red and black motor wires in the control box.
I
MPORTANT
N
OTE
:
The
awning must operate as described if the wind-sense auto retract is installed. If the
awning operates in reverse of the markings, the system will try to extend the awning instead of retracting
the awning.
N
OTES FOR
S
WITCHES AND
R
EMOTES
•
Transmitters operate on a frequency of 433.42 MHz.
•
Transmitters use a 3V Lithium Battery (CR 2430)
•
Maximum operating range is 65 ft. Actual distance may vary based on installation.
•
The control box may be programmed for up to 12 transmitters (switches and remotes).
•
Programming additional transmitters may be accomplished as described previously or can be done using the
existing transmitters. To use an existing transmitter: press the programming button of the existing transmitter
for 3 seconds then press the programming button of the new transmitter for 1 second (max).
Mounting the Optional Anemometer
The optional wind-sense auto retract system uses an anemometer to measure wind speed. When the wind
reaches the user set value, the awning will automatically retract.
Cover
Access
Cover
#10 x 2 1/4
Wood Screws
SunDay011
Figure 13. Mounting the Anemometer.
1. Remove the outer cover and the access cover.
2. Knock out one of the holes at the bottom of the base.
3. Route the furnished cable through the hole and under the clamp plate in the base.
4. Attach the wires to the terminals as shown in the wiring diagram. The wire colors are not pin specific.
Table of Contents
Summary of Contents for SUNDIAL PATIO AWNING
Page 20: ...Table of Contents...
