C
AREFREE OF
C
OLORADO
S
UNDIAL
P
ATIO
A
WNING W
/
M
ANUAL
O
VERRIDE
4
052537-001r5
5.
Below is the minimum number of required mounting locations. Each position uses two screws.
Awning Length
12' 13' 14' 15' 16' 17' 18' 19' 20' 21' 22'
# of Locations
4 5
6
6.
On the plate mark the location of the mounting locations. The inner mounting locations should be spaced as
evenly as possible between the outer mounting locations. Locations must match the frame location pattern.
If using the optional roof top mounting brackets, adjust the pattern to match the bracket mounting holes.
7. On the mounting plate drill 7/16” holes at the marks made in the previous step. The grooves in the
plate are the vertical locations for the holes. Each location has two holes.
Grooves
.5" (ref)
MIRAGE004b
O 7/16”
3" (ref)
4 1/2" (ref)
18” Max
(typ)
Hole Pattern to Match Structural Frame
Figure 4. Mounting Plate Hole Drill Pattern.
8. Position the mounting plate on the wall using the marks made previously.
9. Determine the best method to attaching the plate to the wall. Examples for attaching are shown in
Figure 5. Bracket attach details are suggestions and may not cover all circumstances. If unsure,
consult a builder or engineer prior to installation.
Structure
Use for Wood
Use for soft material
such as Stucco
Sundial003
Siding
Ream To
Match
Standoff
Use for Styrofoam
Filled Siding
Wall Surface
3 1/4”
O 3/8”
Ream To
Match Shield
Concrete or Brick
Use for Brick
and Concrete
Lag Shield
(not furnished)
Structure
Wall Surface
Structure
3/8 x 3
Lag Screw
1” Washer
3/8 x 3
Lag Screw
1” Washer
3 1/4”
O 5/16”
Standoff
(not furnished)
3/8 x 3
Lag Screw
1” Washer
3 1/4”
O 5/16”
3/8 x 3
Lag Screw
1” Washer
Standoff
(not furnished)
O 5/16”
Ream To
Match
Standoff
3 1/4”
Figure 5. Attaching the Mounting Plate.
10. On one end of the plate, use the plate as a template and drill an 11/32” pilot hole into the structure.
Attach the plate using a 3/8 x 3 lag screw.
11. Confirm position of plate and repeat step 10 on the opposite end of the mounting plate.
12. Continue to drill and attach using the 3/8 x 3 lag screws until all mounting holes are done.
Table of Contents
Summary of Contents for SUNDIAL PATIO AWNING
Page 20: ...Table of Contents...
