B
UENA
V
ISTA
13
C
ROSSING THE
E
NTRY
S
TEP
If the panel goes across the entry step:
1. With the panel attached to the RV wall,
carefully mark the location of the top, side
edges of the step.
2. Remove the skirt from the RV and lay on a
flat clean surface.
3. Measure the height of the step.
4. On the skirt, measure and cut a 1/2" slot from
the marks made in step 1. the slot should be
the height of the step + 1/2"
5.
Draw and cut a straight line between the bottoms
of the slots. This creates a flap in the fabric.
6. Slide the skirting over the step and tuck the
flap behind the stair tread. Attach the skirting
to the skirt clips.
7. After hanging the skirting, fold any excess
material under the vehicle and stake as
desired.
C
ROSSING THE
D
OOR
If the skirting is mounted at the floor line or raised to avoid obstacles the skirting
may cross over the door. Simply mark the sides of the door and trim the material
vertically on each side. Fold the excess material behind the panel.
Completed Skirt
bv018
Step 1/2”
Outer Edge
of Step
bv017
Top of Step
Outer Edge
of Step
Outer Edge
of Step
Outer Edge
of Step
1/2”
Top of Step
Step Height
