Carefree of Colorado
4
F
IRST
T
IME
P
REPARATION
The room rafter is shipped with various end fittings to match the awning that is
used. It is necessary before setting up the room to attach the correct fittings on
the rafters.
C
AMPOUT
R
AFTER
1. Locate the 3/4" square plug and press fit into the small channel.
2. Locate the 1" square plug and press fit into the larger channel.
3. Repeat steps 1 & 2 for the second rafter.
F
REEDOM
W
ALL
M
OUNT
R
AFTER
1. Locate the 3/4" square plug and press fit into the small channel.
2. Locate the Freedom Wall Mount case connector, slide it over the small
channel and plug. Note the orientation as shown.
3. Attach the connector using two (2) #8 x 1/2" truss head screws through the
connector and bottom holes of the small channel. Do not over tighten.
4. Insert the lead rail end plug into the large channel. Note the orientation as
shown.
5. Attach the end plug by pressing the push-in clips through the channel and
into the end plug.
6. Repeat for the second rafter.
3/4” Square Plug
1” Square Plug
Latch Lever
(ref)
we011a
3/4” Square Plug
Freedom Wall Mount
Connector
#8 x 1/2”
Truss Head Screw
(2 plcs)
Push-In Clip
(2 plcs)
Lead Rail
End Plug
(2 plcs)
Latch Lever
(ref)
we011b
Freedom WM (Wall Mount)
