Carefree of Colorado Service
Manual
E
CLIPSE
052547-301r10
17
D06
A
A
WNING
D
OES
N
OT
A
UTO
-R
ETRACT
D
URING
W
INDY
C
ONDITIONS
-W
INDSMART
NOTE: The mode switch must be set to Auto-Retract ON.
A
Confirm that the retract function works using the
EXTEND/RETRACT switch
YES
Function works using the switch; go
to test B
NO
Function does not work with switch;
go to procedure D01 on page 17
B
Test Anemometer
1. Do the anemometer cups spin freely?
YES
Go to step B2
NO
Anemometer defective - replace
2. Test signal from anemometer:
2.1. Remove anemometer connector from control box;
2.2. Place an ohmmeter between pins of connector;
2.3. Have a helper SLOWLY turn the anemometer: Does
the circuit open and close? It should open and close
once for every revolution. When closed, the meter
should read approximately 1000ohms
YES
Plug the connector into the control
box; Go to “Testing The Control Box”
NO
The circuit stays open or stays closed
or the ohmmeter reads more that
1000ohms (2x or more); go to step
B3
3. Test the wire continuity between the connector and the
anemometer.
YES
Continuity OK; replace anemometer
NO
Repair or Replace wires as required
D06
B
A
WNING
D
OES
N
OT
A
UTO
-R
ETRACT
D
URING
W
INDY
C
ONDITIONS
–D
IRECT
R
ESPONSE
NOTE: For series I switches, the Mode switch must be in the POWER ON or AUTO-RETRACT ON positions for the
key FOB to work. For series III switches, the On/Off switch must be ON.
A
Confirm that the retract function works using the
EXTEND/RETRACT switch
YES
Function works using the switch; go
to test B
NO
Function does not work with switch;
go to procedure D01
B
Test Motion Sensor
NOTE: A sensor tester is now available from Carefree. Follow the instructions included with the tester. or
Follow the steps below.
1. Confirm cable is plugged into connector on box marked
“Motion Sensor”
YES
Go to step 2
NO
Correct as required and test.
2. Remove cable from box and inspect connector on cable.
Connector should be wired as shown in the wiring diagram
(page 23 or page 24).
YES
Wired OK, go to step 3
NO
Remove connector and replace
3. Unplug sensor from control box
3.1. Connect a second sensor into control box.
3.2. Set the control switches for the auto retract function
3.3. Hold the second sensor vertically and gently move up
and down.
YES
Awning retracts; original sensor
defective - replace
NO
Awning does not retract; control box
defective - replace
Summary of Contents for ECLIPSE 2015
Page 4: ......
