Carefree of Colorado Service
Manual
E
CLIPSE
052547-301r10
29
LED
L
IGHTING
S
WITCH
I
NSTALLATION
NOTE:
Installers may
choose to furnish the control switch. The installation requires that the power line
(+12VDC) be attached to a dedicated 2A circuit breaker or a 2A in-line fuse must be installed
between the switch and power source. For easy access, locate the fuse close to the switch.
1. Determine the location of the switch.
2. At the switch location, cut a 1 1/8" x 1 1/2" hole.
3. Wire the switch as shown below.
Wire terminals at the switch are .187,
18-24 awg female disconnects.
NOTE:
Allow adequate slack in the
12VDC power line so that the
in-line fuse (installed in step 4)
can be accessed from behind
the switch.
4. Install the in-line fuse:
4.1.
Near the switch, cut the red
12VDC power line to the switch.
Do not strip the insulation.
4.2. Insert a wire end into one of the
wire channels until it butts up
against the stop.
4.3. Fold that half of the connector
body over until the element
contacts the wire. Use pliers to
crimp the connector closed.
4.4. Repeat for the second wire end.
4.5. Slide the fuse into the fuse port.
Ensure that is firmly seated.
5. Press the in-line fuse, wires and
switch into the mounting hole. Secure
the switch using two (2) #6 x 1/2"
screws.
6. Snap the switch bezel over the switch
frame.
LED002b
Vehicle Wall
Red
+12VDC
GND
Single Pole
Single Throw Switch
18awg Wire
(minimum)
Connector in
Roller Tube
LED Strip in Roller Tube
Red
Black
Wire Sewn in
Canopy Hem
18-24awg
Female Disconnect (x2)
ON
OFF
1.13"
1.5"
1.88"
2.9"
#6 x 1/2” Screw (x2)
2A
In-line Fuse
2A In-line Fuse
(+12VDC Line)
Summary of Contents for ECLIPSE 2015
Page 4: ......
