E
CLIPSE
Service
Manual
Carefree of Colorado
32
052547-301r10
A
TTACHING THE
H
ARNESS TO
F
ABRIC
W
RAP
When replacing the canopy only or replacing the canopy harness, it is necessary to attach the cable to the
inside of the wrap.
For vinyl canopies with Weatherguard, the harness is routed in the seam of the Weatherguard, no
additional attachment is necessary.
For other wraps follow the directions below:
1. Open the awning to access the inside surface of the wrap.
2. Clean the inside surface of the wrap.
3. Attach the harness to the inside surface.
3.1. For Alumaguard: Use 1" by 2" pieces of Velcro (loop) taping the harness on each slat between the
joints.
3.2. For Uniguard: Tape the harness to the inside surface using a 2" x 8" piece of Velcro (loop).
3.3. For FLXguard: Position the harness approximately 3/8" from the edge of the material. Attach
using a 1" x 6" piece of clear tape (the tape is a special bond tape available from Carefree).
2" x 8" Velcro "Loop"
1" x 2" Velcro "Loop"
ALUMAGUARD
UNIGUARD
LED008
FLXguard
1" x 6" Clear Tape
Position Wire
3/8" From Edge
Summary of Contents for ECLIPSE 2015
Page 4: ......
