Carefree Installation
Manual
F
REEDOM
O
T
D
070007-001r2
3
I
NSTALLATION
Two standard methods are available to mount the Freedom awning. The awning may be mounted using a
set of mounting plates that attaches to the vehicle wall (refer to page 3) If using adaptor brackets, follow the
instructions included with bracket kit then proceed with "Mounting the Awning" on page 3. The awning may
also be mounted using an existing awning rail.
Prior to mounting the awning:
Review both mounting methods to determine the best mounting method for the particular application. The
mounting brackets require access to the inside of the mounting surface.
If there is an awning rail installed, check that the awning rail runs the full length of the awning. The
awning rail must be extremely straight to accommodate the awning mount. The rail must be attached to
structural components for stability.
Ensure that the awning will not interfere with light fixtures, exhaust vents, openings, etc.
A
TTACHING THE
M
OUNTING
P
LATES
1. Determine the optimum positioning of the awning.
1.1. The centerline of the awning fabric is offset from the centerline of the awning assembly. To align
the center of the fabric, use the backplate of the awning assembly for measurements.
1.2. The bottom of the mounting plates should be a minimum of 7" [18cm] above any openings or
frames to avoid interference when the awning is installed.
2. Mark the position with a chalk line.
3. Determine the correct plate pattern then use the plates as a template and drill 5/16" [8mm] holes
through the vehicle wall to match the plates.
NOTICE
For proper operation of the awning, the brackets must be placed under the arm
knuckles. If it is necessary to position the brackets differently than shown in Figure 3, use the
knuckle positions shown.
4. Attach the plates using the supplied M6-1 x 50mm carriage bolts, fender washers, nuts and bolt covers.
Mounting the Awning
1. Set the awning into the hooks of the mounting plates.
2. Adjust the position of the awning horizontally as required.
3. Attach the awning case to the mounting plates using two (2) self-
tapping #6 x 3/8" screws for each bracket.
Edge of Back Plate
Edge of Back Plate
3.5"
[9cm]
1.75"
[4.5cm]
Awning Length
12cm
12cm
WM002a
1" [2.5cm]
1" [2.5cm]
M6-1 x 50mm Carriage Bolt
8mm [5/16"] Hole
Mounting Plate
Nylock Nut
Fender Washer
Bolt Cover
Back Plate
Mounting Plate
#6 x 3/8” Screw
(2 per Bracket)
WM005a