P
IONEER
L
ITE
P
ATIO
A
WNING
10
LED002b
Vehicle Wall
Red
+12VDC
GND
Single Pole
Single Throw Switch
18awg Wire
(minimum)
Connector in
Roller Tube
LED Strip in Roller Tube
Red
Black
Wire Sewn in
Canopy Hem
18-24awg
Female Disconnect (x2)
ON
OFF
1.13"
1.5"
1.88"
2.9"
#6 x 1/2” Screw (x2)
2A
In-line Fuse
2A In-line Fuse
(+12VDC Line)
4.
Install the in-line fuse:
4.1. Near the switch, cut the red 12VDC power line to the switch. Do not
strip the insulation.
4.2. Insert a wire end into one of the wire channels until it butts up against the stop.
4.3. Fold that half of the connector body over until the element contacts the
wire. Use pliers to crimp the connector closed.
4.4. Repeat for the second wire end.
4.5. Slide the fuse into the fuse port. Ensure that is firmly seated.
5.
Press the in-line fuse, wires and switch into the mounting hole. Secure the
switch using two (2) #6 x 1/2" screws.
6.
Snap the switch bezel over the switch frame.
