P
IONEER
L
ITE
P
ATIO
A
WNING
9
LED
S
WITCH
I
NSTALLATION
(F
ACTORY
O
PTION
)
These instructions are for the optional factory installed LEDs in the roller tube.
For aftermarket LED Upgrades refer to: 052593-001, White LED Upgrade or
052594-001, RGB LED Upgrade.
S
PECIFICATIONS
M
OUNTING
:
LED light strip is factory mounted in a specially designed roller
tube.
Wire is concealed in canopy hem.
L
ENGTH
:
Available for awnings 10' – 21'*
* Maximum LED strip length is 16' 5". Strip is centered in roller tube for
units longer than 18'
P
OWER
:
1A, 12VDC
C
ONTROLS
:
1. Single pole, single throw switch (SR0101)
Note:
The Switch kit is ordered separately. Kit includes in-line fuse
holder and 2A spade type fuse.
For an installer furnished control switch, see note under "Switch
Installation".
1.
After the awning has been installed, open the awning to allow access to the vehicle wall below the canopy and awning rail.
CAUTIONS:
The wire should be secured to the wall of the vehicle where it is exposed on the
outside of the vehicle. Use a quality silicone sealant/adhesive.
Do not route the wire over sharp edges or heat sources that can cut or fray the
wires or wire insulation.
Damage that is a result of improper routing may void warranty.
W
IRE
R
OUTING
,
S
TANDARD
1.
Drill a 3/16" hole into the vehicle wall below the
right edge of the canopy.
2.
Route the wires from the canopy into the
vehicle. Allow slack in the wire between the
canopy and the wall. Seal the hole and wires
with a quality silicone sealant.
NOTE:
There is approximately 8 feet of wire from
the wall entry point. Controls should be located
within this distance.
S
WITCH
I
NSTALLATION
NOTE:
Installers may
choose to furnish the control switch. The installation
requires that the power line (+12VDC) be attached to a dedicated 2A circuit
breaker or a 2A in-line fuse must be installed between the switch and power
source. Location of the fuse should be close to the switch for easy access.
1.
Determine the location of the switch.
2.
At the switch location, cut a 1 1/8" x 1 1/2" hole.
3.
Wire the switch as shown below. Wire terminals at the switch are .187, 18-
24 awg female disconnects.
NOTE:
Allow adequate slack in the 12VDC power line so that the in-
line fuse (installed in step 4) can be accessed from behind the switch.
3/16" Hole
Route Wire With
Slack Between Canopy
and Wall
LED001
