Carefree of Colorado
Installation
Manual
T
RAVEL
'
R
052540-002r14
11
6.
To secure the tractioner, drill a 1/8” hole through the tractioner and roller tube; roughly center the hole
between two slots of the roller tube.
7.
Secure with one (1) #10 square drive screw.
A
TTACHING THE
F
ASCIA
The fascia fits between the two struts of the lower arm.
1. If open, close the awning.
2. On the outer channels use a non-permanent method of marking and mark
the bottom of the inner channel. Repeat for both arms.
3. Open the awning.
4. From behind, slip the fascia between the outer channels of the lower
arm. Align the mounting dimples of the fascia with the mounting slots
in the outer channels.
5. The fascia should sit approximately 1/8" below the marks made in
step 2.
6. Press the fascia between the channels until the dimples snap into the slots.
7. Repeat for the other arm.
TravelR001
Facia
End Cap
Slots in
Channel
