ENG
3. Assembly
3.1
Preliminary
operations
3.1.1 Removing the cover
For steam blower installation or maintenance, remove the cover from the appliance as described below:
1. Disconnect the blower from the power supply;
2. Unscrew the two fixing screws placed on the top of the cover;
3. Pull the cover up by slightly turning it forward to release it.
Fig.3.a
3.2
Assembly
3.2.1 Wall-mounting
Important:
mount the blower only on masonry walls.
Fixing the blower to the support
Procedure:
Fig.3.b
Fig.3.c
1. Remove the cover (see previous paragraph). Unscrew
the screws (A) and remove the bottom panel (B).
2. Remove the screws and extract the support from the
blower.
Fig.3.d
Fig.3.e
3. Make the holes in the wall to fix the support.
4. Use a spirit level for mounting
12
| 3. Assembly
VRDX030222195 rel. 1.2 – 22.03.2019
Summary of Contents for VRDXL00001
Page 2: ......
Page 6: ......
Page 20: ......
Page 31: ...ENG VRDXL00001 030222195 rel 1 2 22 03 2019 17 ...