16
Do not install the car seat if the
airbag for the front passenger seat is
activated.
?
1
?
2
?
2
?
1
4
ADVICE ON PROPER CHILD SEAT PLACEMENT IN YOUR CAR
5
INSTALLATION FOR GROUP I (9-18 KG)
Place the car seat forward-facing on a passenger seat and adjust the seat tilt position to maximally inclined (
A-1
, see
point D). Unfasten and remove the linking rod from the seat shell (
A-2
). Push the seat forwards (
A-3)
.
Pull the 3-point car belt in such way, that the lap part of the belt goes through both lower lap belt guides and the
shoulder part of the belt goes through the hollow in the middle of the seat shell back part. Put the car belt tongue into
the buckle until you hear the ‘click’ (
A-4
).
Press the lever on the shoulder belt guide on the car belt buckle side of the seat and slide the shoulder part of the car
belt into the belt guide (
A-5
).
Join back the seat with the back part of the shell and put the connecting rod back in. Rotate the rod to lock the seat
shell (
A-6
).
Tighten the car belt by pulling the shoulder part of the belt in the direction of the car belt tensioner (
A-7
). Before each
use of the seat, make sure the car belts are properly fastened, tightened and that they are not twisted.
Installation of the child seat is
FORBIDDEN if the passenger seat is
equipped with a 2-point seat belt
only.
A car seat of this type may be used only in a car
equipped with seat belts with a 3-point tensor and
a 3-point rolling-up element, which complies with
the UN/ECE Regulation nr 16 or other equivalent
standards.
Proper placement
Forbidden placement
3-point
shoulder
and lap belts
2-point
lap belt
Summary of Contents for Sport Classic
