2012 Cargo Floor B.V. Coevorden, Holland
Versie 01/11-01-2012
www.cargofloor.com
info@cargofloor.com
Cargo Floor B.V.
P.O. Box 271
NL-7740 AG Coevorden
Phone: +31-(0)524-
593900
Fax: +31-(0)524-
593999
Blz. 13
AA)
Forklift trafficable. In principle, the floors are completely trafficable and can be driven over by forklifts, but
always consult your dealer for advice on the maximum loads allowed on your vehicle.
Overloading will cause damage to the Cargo Floor system and the vehicle.
BB)
Always return emergency control(s) to their original non-activated position after use.
CC)
During the operation of the system, test the temperature of the oil by touching the side of the tank. If the oil
is so hot that you cannot continue to touch the tank, switch off the pump to allow the oil to cool off and
determine what is causing the overheating. Stop loading or unloading if the oil is too hot, as this will
irreversibly cause damage to the Cargo Floor system and the other hydraulic components.
WARNING: TOUCHING OVERHEATED OIL AND COMPONENTS CAN CAUSE BURNS AND
INJURIES!
DD)
During loading and unloading operations, the load should be spread to give an even weight distribution over
the floor area, otherwise the load may stall. Tip: when transporting pallets, place softwood boards of 300 x 18
x 2350 mm to distribute the pressure more evenly.
WARRANTY:
Warranty is subject to prior approval by Cargo Floor B.V.! To request warranty coverage, visit
www.cargofloor.com
to fill out and submit the warranty application form provided there; do not forget to include
your Cargo Floor system number on the form.
In the event of an EMERGENCY, operation of the Cargo Floor system can be halted as follows:
By pressing the stop button on the wired remote control unit;
By turning all switches to position “0”;
By putting the handle of the control valve in the middle position (only B and A control);
Turning off the pump;
Turning off the main switch of the power supply;
Turning off the motor of the electro-hydraulic aggregate;
The WARNING STICKER is attached to the outside of the control cabinet.
