5
STEP 6: The Transmitter will now Connect with the Car.
STEP 7: LED ON SOLIDLY and its now READY to play
Just use the TH. Trim to locate the Neutral Position. Nothing else to set.
The ESC is a Forward and Brake/Reverse function.
WARNING:
Maximum is 2S LiPo (7.4V) DO NOT EXCEED this voltage, otherwise will
damage and void warranty.
RECEIVER CONNECTION AND INSTALLATION
CARISMA MRS-24BL RX/ESC UNIT FEATURES
MRS-24BL RX/ESC UNIT SETUP
ESC SETUP
Neutral Position
Receiver (RX) Section
ESC Section
Brushless motor :
Connect Brushless Motor’s Micro 3-wire connector to the ESC.
Over Voltage Protection:
If battery voltage above 8.8V, ESC will STOP operation.
• Auto cu
t-off voltage:
• 1S LiPo, cu
t-off voltage = 3.6V
• 2S LiPo, cu
t-off voltage = 6.6V
Thermal Protection:
Temperate at Thermal sensor appro
x 80~100°C
Motor Overloading and Stall Detection:
Cut-off time is depending on Battery voltage, Motor loading condition, Throttle level, etc.
Max Reverse Speed:
50%
Smart Brake:
When Throttle move from Forward to Backward, the ESC will apply Brake for certain of time, and then drive motor at Reverse direction.
Similarly for Throttle move from Backward to Forward. The time of Braking inserted is depended on what is the current speed of the motor.
RX Power OFF reminder :
After Loss of RF signal over 5 sec., will use LED and servo to warn the user to POWER OFF the car
• LED quickly Flashed 2 times per 2 sec.
• Ser
vo will be mov
ed once shortly per 10 sec.
LED indicator :
Indicator the TX is detected.
2.4GHz Receiver :
HOLD the SYNC button while power up to start pairing to Transmitter.
