9
16. Center the elevator servo arm and the elevator. Apply
a drop of threadlocker on a 3x 5mm machine screw. Install
the machine screw in the quick connector on the elevator
servo arm and tighten it against the elevator cable. Trim off
the excess cable.
17. Route the receiver antenna under the servos and
to the back of the wing saddle. Insert the antenna in the
provided antenna tube inside the aft end of the fuselage.
FINISH THE SAILpLANE
1. Use 6-minute epoxy to glue the nylon tail skid on the aft
bottom of the fuselage.
2. Remove the covering from over the wing dowel holes.
Center the wing dowels in the fuselage. Use thin CA to glue
them in position.
CANOpY INSTALLATION
1. Use thin CA to glue the small hardwood dowel into the
front canopy brace so that it protrudes out approximately
3/8" [9.5mm].
2. Place a piece of wax paper in the cockpit opening.
Center the canopy base on the fuselage. Insert the dowel
in the front canopy base into the fuselage and position
the aft canopy brace, centered on the canopy base. Use
medium CA to glue the forward and aft canopy braces to
the canopy base.