7
Making sure that the servo arms are as shown
above. Insert the set screw into the top of the
pushrod connecter and tighten onto wire.
5
.
Take the wires from both of the servos and
insert them through the front fromer hole.
6.
Place the receiver in the front of the servos.
Plug the servos into the receiver as shown in
your radio instructions.
7
.
Carefully cut through the side of the fuselage
and mount your receiver switch as shown.
Plug the switch into the receiver as shown in
your radio instructions.
Wrap the receiver and the battery pack in foam
and place in the nose. Plug the battery into the
switch.
Take off the servo arms from that top of the
servos then remove the masking tape from the
rudder and the elevator. Turn on the radio and
let the servos move to center Re-mount the
servo arms so that the elevator and rudder are
stright. Screw the servo arms into the servos.
Radio Installation Cut Away View
Summary of Contents for Gentle Lady ARF
Page 14: ......
