7
15
.
Remove the covering between the lines you
marked on the top of the stab where the fin
mounts.
16
.
Remove the covering on the post of the fin,
leave the back covered where it shown on the
rear. Make sure covering is removed on the
bottom of the fin where it sits on the stab.
remove covering
17
.
Mix some epoxy and install the fin. Make sure
it is centered on the front.
14
.
Install the fin in the notch in the rear of the
fuselage. Measure the center of the fuselage
at the front of the stab and align the fin on the
centerline. Make a mark on each side of the
fin on the stab.
remove covering
18
.
Locate the tail wheel bracket.
19
.
Mix some epoxy and install the nylon tail
wheel bracket in the slot provided.