12
Wild Stick .40
tail wheel
tiller arm
into rudder
2. locate the position of the tail
wheel tiller arm and drill a 3/32’
hole. Cut a slot from the hole to the
bottom of the rudder to accept the
wire. Apply a small amount of epoxy
in the hole and fit the rudder in place
on the hinges. Use straight pin to
keep the hinges center as we did on
the elevators.
3. Deflect the rudder to the full
extent of its travel and make sure
the hinge line is closed. make sure the
rudder counter balance clears the
top of the fin and does hit it as it
swings from side to side. Apply a drop
of thin CA to each hinge. Deflect the
rudder in the opposite direction and
apply another drop of glue to each
hinge on the opposite side.
Engine Installation
locate the following parts:
1. Two motor mounts
2. Four 4mmx25mm screws
3. Four 4mm blind nuts
4. Four 4mmx35mm bolts
5. Four 4mm aircraft lock nuts.
6. 8 4mm flat washers
1. Clamp your engine to the two
motor mount making sure that both
sides of the mounts sit squarely on
the table. Make sure the engine is not
offset to the left or right in the
mount. Mark the location of the four
holes.
2. Drill four holes and mount the
engine using the four 4mm bolts and
aircraft lock nuts.
